Msd 8467 Racing Rotor MSD Billet Distributors Installa Bedienungsanleitung PDF herunterladen

WARNING: Disconnect the battery during installation. When disconnecting the battery, always

remove the negative cable ﬁrst and install it last.

Figure 2 Washer Installation.

MSD Rotor, PN 8467

Fits MSD Distributors with Caps PN 8433,

PN 8431 and other GM Window Style Caps

Parts Included:

1 – Rotor, PN 8467

2 – 5/8” Phillips Head Screws

IMPORTANT: There are two different length screws supplied with this rotor. It is important to determine

which screws are correct for your application due to clearance of the magnetic pickup.

Remove the cap and rotor and note the rotor screw retainer that is installed on the bottom of the

advance plate (Figure 1). There are two styles used; one is a Screw Retainer, the other is a Retainer with

a Nut. The Retainer accepts the shorter 5/8” screw while the Nut version accepts the 3/4” screw.

Once the rotor screw length is determined, install the rotor being

sure the round and square aligning pegs are lined up correctly. Install

the Belleville washers with the dome facing up on the screws and

tighten the rotor (Figure 2). Install the cap and plug wires.

Figure 1 Determining Rotor Screw Length.

Note: It is recommended to install the rotor and check the

clearance before reassembling the distributor.

ROTOR SCREW

RETAINER

ROTOR SCREW

RETAINING NUT

USE 5/8"

SCREW

USE 3/4"

SCREW

2 – 3/4” Phillips Head Screws

2 – Belleville Washers

M S D I G N I T I O N • w w w . ms d i g n i t i o n .c o m • ( 9 1 5 ) 8 5 7 - 5 2 00 • FA X ( 9 1 5 ) 8 5 7 - 3 3 44

1 2

WARNING: Disconnect the battery during installation. When disconnecting the battery, always remove the negative cable ﬁrst and install it

TECH NOTES_________________________________________________________________________________________________________________________ _________________

Keine Kommentare

Msd 8467 Racing Rotor MSD Billet Distributors Installa Bedienungsanleitung